Hey guys,
I need some help as I build this PID Controller for my Lee pot.
Here's what I've got so far:
Components:
Pid from Lee's benefit sale, switch, temp probe, solid state relay, old bluetooth headset charger for DC power supply, terminal strip and fuse holder.
I bought a project box from Radio Shack, but it's going back. For one its too small - I don't think I could fit everything in without a lot of effort, and maybe not at all. So I started looking around the reloading room for a box big enough and I found this:
I bought a new Glock a while back, and didn't like it - when I sold it, I forgot to give the guy the box. Anyway, I shouldn't have any problem getting all the stuff in this box.
I've got the holes cut for the PID, the switch, and the plug for the probe.
I think it will turn out o.k.
I have a question: What type of glue/adhesive should I use to hold all these components in place? I don't want all this stuff to just be rattling around in the box do I?
.