Last edited by TylerR; 12-24-2020 at 05:02 PM.
Yes it is the 634js. I made a mount for the Dillon 750 and an enclosure for both units. Along with the enclosure I made some ball and socket connectors so it is easy to remove and adjust location.
The 7 doesn't fit.
8 fits the 1/4.
10 fits the 5/16 and the 3/8 but it might go a little loose over time. I can't pull the spring out, so it's good.
13 fits the 1/2 but is a little tight. That could be my print because I had some stringing.
I'll try with some projectiles and cases later, I just had a quick minute.
1mm except for the 1/2 which is 1.1 mm.
Hi Tyler, just printed the #9 drop tube to sit on top of the M Hornady feeder die adaptor, however, they did not couple well. #9 Drop Tube ID I can measure max came out to be 16.35mm while the OD of the Hornady Feeder adaptor max came out to be 16.60mm. All other parts I've printed so far coupled nicely except these two. I was wondering what was your design dimensions...? I'll sand and get these couple, just wanted to provide feedback...
Merry Christmas to all of you Stay safe and enjoy the company of your loved ones.
Merry Christmas to all... Stay safe out there and have your self a wonderful new year!
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |