I need a little help to get me going on the right direction. First off my casting experience is with BPCR bullets and muzzleloader round balls.
Id like to get a mold for my .44 mag Henry and my G2 Contender.
I read with interest about the .44 SWC molds in another thread. I believe it was a MP mold.
If i am reloading for a .44 mag rifle are the higher velocities going to dictate the need for a gas check design? Besides bullet fit is powder coating a suitable replacement for gas check to keep down leading?
Id like to keep the bullet weight around 240.
What bullet molds would you experienced guys consider?