i just got one of these molds new and i got a partial casting session with the mold.
she throwing right at 158 grs. i'm usunf ww and a lb of 50-50 lead.
anybodyhave any suggestions to get em up to 170. thanks dan
i just got one of these molds new and i got a partial casting session with the mold.
she throwing right at 158 grs. i'm usunf ww and a lb of 50-50 lead.
anybodyhave any suggestions to get em up to 170. thanks dan
Your modern version of this mould is casting very light! My older 1 and 2-cavity versions cast at 172 grains in WW+ 2% Sn.
You will only gain about 6-7 grains even by going to pure lead. LYMAN has changed this mould a bit but I did not know it was that much !
Perhaps others with the new version will post their findings.
Jerry
S&W .38/44 Outdoorsman Accumulator
Wow, that's light, I have a newer one that is casting at about 168 with straight ww.
Send Lyman an e-mail, they may have mis-marked a 358477.
[The Montana Gianni] Front sight and squeeze
I agree with the other posters: that's too light. My six or seven year old four cavity Lyman 358429 dropped 'em at 172 WW. Look at some pics to see if they mismarked it.
Cat
Cogito, ergo armatum sum.
(I think, therefore I'm armed.)
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |