Please help, I really couldn't make a nice looking bullet with my reloading set up for 30 M1 carbine.
I used the following dies:
sizer - lee carbide
lee powder thru expander
hornady seater die
lee factory crimp die
When the brass comes out of the powder thru expander, the other side of the mouth bulges noticeable and when I seat the bullet, it was crooked, and was really bad looking ammo!
I resized the brass in a forster coax press, and use and lee classic turret press for the powder drop, seating and crimping. But whatever method I do, I couldn't make the bullet seat nicely and without the bulge on the other side of the case mouth.
What's the problem here?