i want to show you something

[44man]

I got the dies fixed, removed the rust, made a new headed primer punch, straightened the threaded part.
I chucked the expander and cut the bottom of the die smooth. I went to remove the seat punch nut and could hardly budge it, Got it off and found plier marks on the threads, trip through a die fixed that.
The more I think about it the more I think he ran the expander into a .41 case.

[1911cherry]

I still love the story of a friend who threw a weed eater out in the front yard and proceeded to empty a 16ga pump shotgun into it.. I bet that one will NEVER put up a fuss again ya think?

I am extremely mechanically inclined ,an engine technician by trade.
I too have shot a finicky weedeater except I used a .45

[Gtek]

IMHO the Liberal Progressive left over the past several breeding cycles has been able to install safeguards that would naturally inject chlorine in many of these gene pools. So much for the strong herd!

[44man]

I am extremely mechanically inclined ,an engine technician by trade.
I too have shot a finicky weedeater except I used a .45

Some cheap machines can't be fixed, Mac10 chainsaw comes to mind, the Poulan small chainsaws, no bearings on the piston pins, needs 25 to 1 mix or it will lock up. Cheap weed whackers that refuse to start.
Lot of problems are carboned up exhausts but after a carb rebuild and exhaust cleaning, still needs shot. Rings, seals, etc still OK.
The Mac10 was a two limb saw until it would never run again. Some of that junk will give you a Popeye arm!