This is the first deer for this gun 38 yard shot complete pass through broadside broke both shoulders and got into the spine. Lyman 410459 HP (212 gn) cast from wheel weights pushed with 9.2 grains of unique win primers It been a lot of trial and error with this gun for load work up. Bought a lyman 410459 mold last year and had trouble getting an accurate load worked up. With my saeco 220 gn rnfp mold this gun cuts a raggd hole at 20 yards with imr 4227 Got to measuring bullets out of the lyman and they mic .409 -.410 ish out of round ended up lapping the bands and beagling the mold to get a round full sized bullet . Then I got fed up with pan lubing and bought a lyman 45 sizer should of done it years ago. On to powders for some reason this bullet/gun combo did not like imr 4227, h110 or 2400 fair accuracy but not like the saeco’s . Started messing with unique and 9.2 grains was the sweet spot just drops them in there not a barn burner but consistent . Sitting on the ground with my wrists resting on my bipod I’m able to shoot a 2 -3 inch group at 40 yards( tasco accudot scope). I’ll post a picture of her tomorrow.