Hello. My name is H.Callahan and I am a mold-aholic...
Hello. My name is H.Callahan and I am a mold-aholic...
All I can offer is to take two asperin and get out your check book in the morning.
Mold arrived this morning. Utah and Swede is apparently a LOT closer to Montana than Slovenia and Miha. Much quicker turnaround when I order from NOE.
I cast a hand full in pure lead as I need to slug three 9mm barrels. Even a bit wrinkly in a less than up to temperature mold they looked NICE.
Slugged my barrels and they ran from .3565" to a full .357" so the .360" diameter mold was a good idea. Ran a few through my .358" sizer, loaded a few dummies and they chambered easily in all three pistols.
Pulled two bullets and they were only slightly undersized from the taper crimp. Almost nothing. Cast from a harder alloy I may be OK. FINALLY something POSITIVE in the 9mm quest!
So far so good!
Next I need to cast some bullets, have a WW's with 2% tin mix in the pot already.
Maybe things are looking UP??
FN in MT
Please accept my offer to buy your used molds when you move on to your next hobby
Did you ask to have a mold made that big--.360?
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |