Sometime back I mentioned that I bought this trainer. Disassembled it and except for the bbl all the parts are in good shape. Question is, how do it get the bbl out of the receiver?. I removed the pin that went through the receiver and bbl and tried to drive it out with a 3lb hammer and brass bar. No good. I'm thinking that I will have to drill out part of the bbl stub and remove metal and hopefully lessen the compression. Last resort would be to go to a bearing shop or get use of a hydraulic press to push out the stub. Any suggestions?. The other question is easy-off oven cleaner. Has anyone used it and what does one do with it. The stock is in good shape (barely) but has a lot of scratches and dents and they are filled with dirt and old oil. There is enough wood so I can try and raise the dents and hopefully remove most of the scratches and stuff. I at one time used a carpet cleaner spray that was designed to remove oil stains from rugs. Spray it on and a white powder would form lifting the oil from the woods pores. Do not have any more. Any suggestions are appreciated. Thanks, Frank