This buy is For a MiHec clone of the classic Thompson 358156 HP
These are the options . .
1. We'll go for both two and four cavity brass, but that requires fifteen orders for each. Only if the fifteen are ordered will the mould get cut. Please state your preference, and a second choice if you have one.
2. Available in .358 and .360 diameters (WW). No mixing cavities.
3. If you prefer a solid, that's also available. No mixing of cavities, though.
4. HP molds come with one set of round pins. Additional penta pin sets are $16. Blank pins, also $16, are made on request. Blanks are pins you can customize by yourself. Lastly "plug pins," also $16, are available to cast solids if you want to avoid the hollow point pins projecting from the bottom of the mold when reversed.
Please include your (disguised) email address with your request. Miha will send out invoices about the time the buy gets closed. Payment's through PayPal (he's in Slovenia).
A plain base is possible, but would also require fifteen orders. Feel free to post if you're interested, but this buy is for the GC design. Enough interest and I'll assemble a list.
HP Price: $90/2C + $16 extra pins +$15 shipping
$120/4C + $16 additional pins + $20 shipping
Solid Price: $70/2C + $15 shipping
$90/4C + $20 shipping
Discussion thread: http://castboolits.gunloads.com/showthread.php?t=125623
There's lots of searchable information about this venerable design; a great choice for 38 and 357, and here in one of Miha's superb Cramer brass HP moulds. This'll be a good one!
Sam