Search:

Would the hammer out of an old model single six be the same/fit? there are a couple on ebay for the single six, just not the blackhawk.

It's not a conversion hammer, checked that out yesterday.

I already have a single six 3 screw and a 44mag super blackhawk three screw. That's why I am so interested in this one, I really like them.

I'm going to see if I can pick it up somewhere south of $300. Worst case scenario is having ruger convert it and end up with a $300 gun. Best case I get it fixed and have a sweet little revolver. ...

I found a 3screw 357 BH today at a local shop and it is confusing me. It is not converted but doesn't have the loading notch. If you hold the hammer back to where the notch should be the cylinder...

It is a 408 Cheytac system, not a Barrett.
http://i259.photobucket.com/albums/hh284/CTone03/Guns%20in%20movies/Shooter/Shooter408CheyTac.jpg

Several of the builds they have done are not legal to own without NFA paper work.
Someone who was on the show posted about the experience, said the story was real but the gun they "built" wasn't...

I work at a bowling alley and get requests all of the time for them for this exact reason. If your local bowling can't help you out I will send you one for the price of shipping.

you can order the Zmax (green tipped Vmax) bullets right now for $58/500 comes out to $0.11 each. I'm local to the 5500 pack and it doesn't get me excited.

The McDonald's straw upgrade is very helpful.

Get a straw for McDonald's (the fat ones from any fas tfood should work) and cut a short piece to place in the dispensing tube covering the cut in...

Your missing an "H" in that address. Try again and see what happens.

I'm happy with paying $45 to get it fixed, way better then the $200 to replace teh dispenser alone. This was 100% my fault, I didn't expect RCBS to do anything about it.

RCBS said I could send it in and get it taken care of for $45. I'm going to do that since even if I get the powder out it's still messed up. I can't get a pic to come out worth a darn, so no pics.

I have been working up a load for a buddy's 9mm over the last couple weeks. Got some test loads done up a couple weeks ago and finally got to shoot them over the weekend, all is good so far. I use...

I saw a truck go through town here with a couple solid bars of TI. 36" round by 15' long give or take. I wonder what that would be worth?

Payment sent for the 1911 grips. I threw in an extra five just to help out.

I'm a little young to know what the '70s were like but it for sure swung to the left at some point. There are still alot of great people here though.

that's down the road a ways.

Got most of my stuff set up, looks a little better now. Several presses and all of the casting equipment is missing from these.

looks great, many thanks.

Non-Toxic is what the NT stands for, they use small pistol primers for some reason beyond me. Really annoying to not notice it until its in the press with a primer jammed somewhere it shouldn't be.

The picture of the charge master after the destruction.

Where is the required attachment?

1007 on my first try. #38

Got the new bench put together last night, I finally get to do my reloading in my house instead of driving across town to my parents garage. :bigsmyl2: