Search:

I'd trust gas check and good lube over paint any day.. Heck.. you could gas check..paint it AND lube it and get whatever magical benefits happen with the paint.. plus the proven stuff for the lube...

Can't help with sights.. but I do load for my 444 marlin. First off..I cast for about 99.5% of the stuff i shoot..and almost universally..I like cast better.. there are a couple exceptions.. and...

Would you say a 357 mag is marginal for defense? You can load 327 into 357 ranges.. meaning you think 357 is marginal for defense. Same with game.. If you don't think 357 can take a small to medium...

It's a great gun.. I have one. After you get this..then look at 30 super carry...

You can load them right up to 357mag specs..discounting heavy for load weighted projectiles. I love my 3" ruger Sp101 in 327. Can shoot 327 32 mag..32 long/short and usually acp depending on the...

I load for a couple old Turks..rough lookig rifles..but decent bores..cast n gas checked do great on paper for me. i use the lee c-324-175-1r mold.

No such thing as too big. I shoot full wadcutters seated slightly out f the case for 38SW in my old Brit revolvers..looks great..paper target thinks they are great too. I imagine a bad guy would...

i shoot cast and gas checked 8mm mauser..accuracy is fantastic. Victom is a rough looking Turk..but has a great bore..

How will muzzle loaders handle this? Tin seems too hard?? Bismuth?

Wow..gotta love so many standards!

I'm using an MP hornet mold with a gas check.. No tube mag on my gun.

Update: might have found my parts at Apexgunparts. Waiting to see if they respond.

Hinge pun screw I guess is what it's called. Any wag what thread it could be?

Working on a enfield revolver.. the ones chambered in 38/200 mk1 no2

I am looking for what is called a cam lever..external part.. held on with a screw and locates on a pin. I can find the lever...

I reload them.. but with jackete projectiles.. have yet to ever find a mold and sizer..or I'd load cast...

I use coww for buckshot. Seems to do great. Slugs I tend to cast soft.

I think you'd be fine with it.. And for s&g's I'd see if a .359 projectile in a dummy case will drop in and fall out of the cylinder. It's likely the restriction of the cyl mouth is at the very end...

The images above in post 1 are of hollow point?? It's a small opening.. but AFAIK..it counts as HP not fmj.

yup..good for glocked brass..or other unsupported chamber guns.. A lee FCD with a sizer ring usually works too

might have been ddt..

yup..drips and powder sacks.. I use them on cattle strung across a narrow gate they have to pass thru to eat.. good for swine too.

The cast lead simply swage down passing the throat to the forcing cone.

Wow..huge difference!

reminds me of an arbor press. Wonder if it was a grommeting press..?

I use a case gauge just as a go / no go quick check on like 1 in 20 rounds. Your guns chamber is the real test..though if it passes a case gauge..it should fit ANY gun. I doubt the oversized...