Search:

Can you share the .stl?

I have black wire from sensor going to in negative on the relay (as in image in manual) and blue from the censor connected with - Power on speed controller and 12 V negative going to the - on the LED...

Sensor is three wire, and is the one from the manual off eBay. Only difference in the wire diagram above you have is your switch has 2 connectors and mine has 3 which is the one from the manual as...

Help Request, in the past I have always used the micro switch option with the Cherry d42x for the micro switch. I wanted to jump on board the proximity sensor as that seems to be the leader these...

Looks Awesome!

Toby, let me know which motor you decide to go with because I am doing the exact same thing right now. Printing a Mongo for case feeding for .45acp into my decapper and then I'd like a clean version...

Did you ever get this to work Lablover?

Thank you, trying to size some .357 boolits this weekend and printing the small plate now. I thought it would work but wanted to double check prior to printing. I will let you know how it goes:)...

Which collator plate are you using for.357 bullets? Small pistol?

Thank you! I can do that.

Question, I know I can make the collator plate for the original ammo mike design size but can I also do the same for the slide plates?

I mailed the 160 flat base no nube groove ones today

Been there my man, I have a few "coasters" on my desk from the power outtage.

If you are up for it I'll send them to you. Just PM me address to send and I'll mail them out next weekend when I'm back at the ranch. I poured roughly 6,000 of them for him so he won't miss 20-30 of...

Good Idea, I will try the 9MM ramp. The ramp I found to work best was that one from backyard inventer where it had the trough for the bullet to fall into and that seemed to help quite a bit but still...

Want me to USPS you 20 or so of them? :)

I agree GWS, I will NOT load that bullet but my Father is another story and he is a Bullseye shooter and that is his preferred bullet for 25 yards so I'm trying to help the guy who gave me life :)

Will do. Quick question, in the experiment folder there is a Dillon adapter, is that the one you are using on your case feeder to run a spring from vs the Dillon plastic tube?

I did, I made the hole 11MM vs 11.5 and also tried 11.3MM. The darn bullet is almost square which causes the issues and ramp doesn't work. I may try to increase the depth of the pivot but I'll keep...

With the pivot print and a plate height of 11 vs 13 it seems to eliminate the sideways trap but I'll test more this weekend and let you know.

Ok, possibly dumb question here but has anyone gotten a 160GN SWC 45 ACP type bullet to work with their feeder? I've been working on getting it to work for my father as that is his preferred bullet...

Did you find someone to build one? I'm also interested in getting one.

I figured it out, I couldn't updated it to 11.5 in openscad so I just used a txt editor to change the default value from 9 to 11.5 and boom it works.

Tried comma, it changes 11,5 to 115. When I try to type 11.5 for the 45 ACP all it allows me to type is 11.

Can you post a picture of that chute that comes out the front?