Search:

Any reason not to use ceramic as in the tumbler?

So for my purposes I should get:

12-16 for Fg

16-20 for FFg

20-40 or 50 for FFFg

My main concern is getting good Fg and FFg, I don't have a purpose for FFFg currently but I am sure I will...

This thread is stuffed full of excellent information. I have read through around 1/4 of it so far and have learned a ton!

I am sure the answer to my question is somewhere in the 395 pages here but...

That's a good question, I look forward to seeing what works and what doesn't.

I will be trying to find apropriate sized washers when my mold arrives.

Thanks for the input guys there is lots to think about and experiment with!

Also should menchin that I will be spraying my bullets unless there are benefits too the plastic BB method?

I am going to start casting for my .223 Handi Rifle. I am hoping to get a fun reasonably accurate round to replace my .22LR for squirrel and rabbit hunting. I went ahead and bought the Lee 225 55...

I have not had any problems with the HF matte black. But I have also not shot 3k rounds out of any one gun. Interesting to see what others have to say.

Thank you for all the replies guys, I think I have a pretty good idea of what I am going to get now!

I am 23, I started casting for big bore airguns a few years ago and it slowly progressed into casting for I think 8 different calibers now. I went all in and bought the powder coating set up and...

On most forums I am a part of I will ALWAYS pay with paypal and will make sure that I don't pay as a "gift". The gift option leaves the buyer with nothing to stand on in the event of a scam. I have...

Thanks for the suggestions I will look into those molds a little more. :grin:

I have seen 1,900 fps talked about on a lot of threads as the "go to" velocity that lead performs best at.

Seems I may want to go with the heaviest bullet that my barrel twist can support to make...

I guess I should also ask what BHN you guys are using? I shoot softer lead between 8-10 BHN but would be willing to up the alloy if there was data to support it.

I did not see an introduction thread so I will post a short one here:

Hi, I am Brian from Hunt NY. I am an avid shooter/handloader with a few years casting experience. I am a machinist by trade....