Thank you Bazoo!
Printable View
Well it looks like the package was lost. Contacted merchant and it was shipped 1/2. UPS doesn't have it. So now have to wait for merchant to reship it.
Like this:
Attachment 321946
Lee 356-120-TC 6 cavity mold; GTG. Drops at .358 with alloy @ 11.3 BHN. Use .357 sizer for .356 slug. Powder Coated; No Leading. Have used this alloy up to 1600 fps with great results.
I received the package on 1/11. So now I have everything I need except for some anti seize lube, gloves, and warmer weather.
I hope you try the tumble lube Lee 124 TC mold. I have one in 6 cavities and found it cast incredible bullets at higher temperatures. The bullets frost slightly and fall from the mold mostly. Using BHN 12 or so alloy and I do not size at all for my M9A4 Berretta. My buddy has a Canik and the same bullet must be sized to .356 or the slide won't close. They are all different in some capacity. That TC bullet though out of my Berretta is scary accurate. I use a load of Silhouette under it. All is well. Hope you find the going easy.
I could only find Permatex valve grinding compound near me. It starts at 220 grit and grinds down to 120 grit. Kept twisting the valve in the seat until the sound of the grinding compound almost stopped. Tested the pot by pouring water into it and the valve stops the water from dripping out. So if it keeps water from dripping, it should keep lead from dripping. I'll see once the weather warms up so I can cast outside. Thank you for your help.
That's the mold I have. Just waiting for the weather to warm up so I can start to cast. Thanks for the comment.