Thanks.
Printable View
Thanks.
I find the 40 about the same as the 9mm top get really good results with. It's about matching powders to bullet alloy. I find the medium burners likw WSF & Unique work really well w/ a 175-180gr bullet runing 900-950fps cast from ww or maybe 3-1 ww/lead mix.
Lee 175 TC -- These drop right at 180gr with water dropped wheel weights. I've got loads for 'em from that go all the way from 810fps to 1020fps with PowerPistol.
http://i10.photobucket.com/albums/a1...IMAG0456-1.jpg
http://i10.photobucket.com/albums/a1...a/IMAG0465.jpg
(Now, play Where's Waldo and find the boolit that somehow got no lube! ;) )
2.5 inches left an 3/4 inches up from bottom-right corner. Bullet faces up with nose hidden and base/groove visible... :D took 5 seconds. LOL
Does anyone use Allox for these calibers? If so how well do they work out?
I cast and load tons of .40 and 9mm. Just finished 1k of 9mm for my Mrs. Ruger. I did a lot of reading on this forum before deciding how to load and what powder to use for the .40. Mostly because it seemed like there were many folks having trouble with it. I happen to like HS-6 or Unique for both calibers. Lube with 45-45-10, size and load. Couple of my molds don't even need sized.
My ¢2
Armorer
In hindsight, I would have gotten a .45.
I agree with gathering knowledge,that is the key to a good start.
That is a tumble lube correct? I have not heard about a 50/50 mix only the 45/45/10. Interesting thanks!
Never give up just keep at it. I had a heck of a time getting my 200 GR. 45 SWC Boolits to work properly. I just kept at it and kept seeking knowledge. I own both and will load for both ,and the 9mm eventually.
me too, Haahhahaha I was just trying to drop the guy a hint, and hopefully save him a LOT of trouble.
Thank you I am going to give this method a whirl. I read about this from a great write up from Recluse about a year ago. I Just need to get a hot plate and some JPC . I will order the molds from Midway .
I wonder if anyone uses Accurate #2 ? I just have a lot of it.
Do you mean Lyman #2?
oh dear, I thought alloy. DOH!
If you know enough to ask that, I think you know the answer.
Depending on your skill/knowledge set, tools, the dimensions of your chamber and leade and the level of performance you wish to achieve, it can be as simple as any other handgun caliber or it can be the nightmare that forever poisons you against cast boolits.
My experience: Either treat it as a .45 ACP and load in the pressure range that will get you about 800 fps or so, use a powder in the range of Clays or Unique, use air-cooled wheel-weights in the 11-15 bhn range, low-pressure lube, etc., OR....
If you want to load hotter, water-drop your boolits to get in the 22-24 bhn range, use SLOW powder like Blue Dot, Longshot, or HS6, get a custom expander die made that will expand your cases to .001" under sized boolit diameter, and use a high-pressure rifle lube like Carnauba Red or Felix lube, and work up near the top end of the safe velocity spectrum.
Forget liquid Alox and factory, jacketed-bullet expander spuds (way too small, causing undersized boolits and severe leading).
Gear