Ditto..
Printable View
Another on the high temp RTV
Was just gonna say that. Works great!
OK so yesterday I used hi temp red rtv to reattach the wooden handle on my Lee 6 cav mold and it works very well now.
A Lil dab'll do ya right, like tooth paste.
I use any old silicone caulk.
I finally put high temperature silicone on it, so far there are no more problems.
J-B Weld ... 2 part , slow setting ,
Do Not use fast settin , 5 min, type or Foamy Gorilla Glue .
Use old school 2 part J-B Weld ... trust me on this ... other glues can't take the Heat !
Gary
tI used JB Weld to repair a seam leak on a radiator back when there was only one JB Weld. It lasted about 30 minutes so I cleaned it out and soft soldered the seam. That lasted for years.
Works for Me +
Gorilla glue has lasted 10 yrs on mine.
Hi temp silicone will take the heat!
Lots of ways to skin the cat, all have been pretty much covered here.
I've always use Elmer's glue or carpenters glue. Just squeeze some in the holes and tap the wood back on . Don't need fancy glue or epoxy.